Additional tail rotor information: When you set up your tail rotor you need to make
sure that your tail pitch slider is not going to hit your tail pitch control lever mount.
With some gyros you can adjust this and others you can't. If you have a gyro that
you can't adjust this all you need to do is take a piece of fuel tubing and slide it
onto your tail output shaft. Spin your tail rotor to make sure the fuel tubing is long
enough but not too long.
Helicopter Center of Gravity (CG):
When the fly-bar is perpendicular to the tail-
boom, pick it up and the nose should be just slightly heavier. If you need to just
move your battery forward to get proper CG.
Step 5 – Canopy Installation
Install (4) 40mm Canopy stand-offs
using (4) M3-10 Cap Head Bolts. After
you have attached the canopy cross
stand-offs you must place the canopy
on the machine and mark the canopy
for the locations of the standoffs. Drill
a 1/4" inch hole in the previously
marked position. After the 4 holes have
been drilled insert (4) Canopy
Grommets and attach the canopy to
the helicopter using (4) M3-15 Cap
Head Bolts.