Install mounting plate below tank
using (4) M3-10 Cap Head Bolts
and (4) M3 Lock Nuts
Note:
For
additional support you may want to
put a piece of double sided tape
onto the mounting plate.
There are three (3) lines
(Aluminum fuel tubing) that need to
be constructed for the tank
assembly. Depending on the
engine you use, you may need
only two (2) lines. One line is the
fuel pick-up line and requires a
length of silicon fuel tubing running
from end of alum. Tube to clunk –
which should be centered in tank.
The other line is pressure-line,
which should be bent to reach the
top of the tank on the inside. The
third line will generally be plugged.
Tighten rubber stopper screw – but
do not over tighten or you will ruin
rubber stopper!
