Hobbico Husky ARF, Руководство пользователя

Страница: 6 / 44

6
1. Collect the following items
(2) 6-32 x 1-1/2” bolts
(2) 6-32 nylon ball nuts
(4) 4-40 x 3-1/2" Double Threaded Wire
(2) pushrod couplers
(2) nylon cup washers
Aileron Control Horns
2. Insert the 6-32 bolt into the aileron from the
top side, no washer is needed.
Install the cup washer on the bottom and then
the ball nut with the ball side toward the wash-
er.
3. Tighten the ball nut against the washer and
screw the pushrod coupler onto the bolt.
10. Hold the flap servo door in the opening and
transfer the mark to the door.
11. Extend the mark across the servo door and
align the output shaft of the servo on the
mark.Make sure you have the servo on the
correct side of the door so the pushrod aligns
with the arm. The servo arm should be 1/2”
over from the edge of the door. Mark the loca-
tion of the mounting blocks.
12. Epoxy the servo mounting blocks in place and
mount the servo.
13. Attach a servo arm to the servo and hook the
pushrod to the arm. You will need the radio on
so you can move the flap switch and adjust
the length of the pushrod until it fits.
It is trial and error until you get the pushrod the
correct length. Fit the door into the opening
and note the position of the flap. Remove the
door and adjust the rod. When the rod is
adjusted and the flap works correctly, screw
the door in place using four #2 x 3/8” screws.
pushrod coupler ball nut cup washer
4. Screw the 4-40 x 3-1/2” pushrod into the
pushrod connector and install a clevis, jam nut
, and silicone clevis keeper on the other end.
Attach the clevis to your servo arm and adjust.
NOTE: Do not thread the adjustable horn bracket
farther than 1/4” down on the 6-32 bolt.
Control flutter can occur when the bracket
is to close to the control surface.