Hobbico Husky ARF, Руководство пользователя

Страница: 10 / 44

10
2. Screw the rigging couplers into the nylon fit-
tings about 3/16” leaving room for adjustment.
3. Locate the holes in the fin approximately 1-
3/4” down from the top and 3/4” in from the
rear. The stab holes are approximately 2-3/4”
in from the tip and 3/4” in from the rear.
4. Install a rigging coupler on each side of the fin
using a #2 screw, flat washer on each
side,and a nut.
5. Install a rigging coupler on each side of the
stab, top and bottom.
6. Install the other two couplers on the bottom of
the fuselage just in front of the tail wheel
bracket, using the two #4 screws.
7. Insert the wire through on of the swages,
through the rigging coupler and back through
the swage. Slide the swage to about 1/4” from
the coupler and and crimp two times.
. Pull the cable to the other coupler and repeat
the crimping.
8. Repeat for the other bottom wire and then do
both top wires.
Rudder Elevator Servos
1. Collect the following items
(1) Rudder servo
(2) Elevator elevator
(1) Fuselage