Intesis
TM
Home Automation (WMP)
– Hisense VRF
User Manual r1.0 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL
http
s
://www.intesis.com
12 / 24
Figure 4.3
Intesis MAPS Home Automation configuration tab
1. Available commands
This is an informative section displaying all commands available for the WMP communication.
2. TCP Configuration.
This section allows to configure the TCP settings for the WMP communication with the Home Automation system.
•
Port:
WMP TCP communication port setting. Default port 3310.
•
Keep Alive.
Set the time of inactivity to send a keep Alive message. Default 10 minutes.
4.2.5. Hisense configuration
Set parameters for the connection with Hisense installation.
Figure 4.4
Intesis MAPS Hisense configuration tab
In Units Configuration section you need to enter, for each unit:
•
Active
. If it’s active (checkbox at Unit xx), ranging from 1 to 64 indoor units that will be integrated (maximum
number of units will depend on Intesis model)
•
IU address
. Address 1..64 of Unit in Hisense H-Link bus.
