HMS BE8510-i, Инструкция по эксплуатации, Страница: 37 / 58

36
Warning:
1) The safety level of the equipment can be maintained only if it is examined regularly for damage and wear, e.g. pins,
connection points.
2) Please replace defective components immediately and/or keep the equipment out of use until repair.
3) Noise emission under load is higher than without load!
GUIDES FOR MALFUNCTION
Analyzing and eliminating malfunction
Item
.
Malfunction Reasons Solution
1
Treadmill can’t be
started
The safe key isn’t in the right
position
Put the safe key in the right position
The electrical switch is placed to
“0”
Turn the electrical switch to “1”
2
Meter can’t display
Check the machine whether it is in
power Check the power cord are connected well
and switch on
The upper communication is
broken
Replace it !
The meter and upper
communication line are not
connected well
Disassembly meter and check the upper
communication line,make sure that meter
and communication line are connected
well.
3
Heart rate can’t be
displayed
The pole of heart rate sensor is not
wet enough Wet the pole with water or liquor for hard
contact lenses
Disturbed by electromagnetism Stay away from electromagnetism
4
Incline doesn’t work
The motor wire is not well
connected
Open the motor cover and reconnect it
5
Running belt runs
faster or slower than
what
has been
displayed
Unadjusted Readjust it
6 Running belt slips Running belt is not tight enough
Please read point 6.3 Adjustment steps
for tightening running belt for reference
7
Running belt is
deflected
The running belt is unadjusted.
Please read point 6.4 The steps for
adjusting the deflected running belt for
reference
8
Displayed E01 on the
screen The sensor wire or motor are
broken Remove the motor cover and change the
sensor wire,motor in return
9
Displayed E02 on the
screen
over power voltage protection Use normal voltage.
10
Displayed E03 on the
screen
over current protection
Check whether it is overloading
Check whether the drive motor can run
normaly.If not,replace motor.
11
Displayed E04 on the
screen
The motor is not in power
The motor wire are not connected well or
the motor are broken
Displayed E06 on the
screen
Connection error
Changing the upper or lower connection
line
Displayed E09 on the
screen
Incline error
The incline motor wire are not connected
well or the incline motor are broken
Displayed E0P on the
screen
Speed error
Setting parameter wrong or sensor wire
broken
Displayed E0C on the
screen
Short-circuit protection PCB MOS broken or motor broken
Displayed E07 on the
screen
Safety key off
Put safety key on the meter or change the
safety key or reed pipe for safety key
12
Displayed E0E on the
screen
Eeprom error
Upper or lower communication line
broken or PCB broken
If you still can’t solve the problems after taking the solutions above, we hope that you can contact our dealer or company as soon
as possible.