HMS BE8510-i, Инструкция по эксплуатации, Страница: 36 / 58

35
MAINTENANCE
Identification ways for the degree of tightness of running belt and poly V-belt.
When the running belt skips, please follow the steps as follows to make sure which belt needs to be adjusted, running belt or poly
V-belt.
a)
Unplug all power supply, screw and remove the Base cover.
b) Turn the speed to be around 3km/h, step on the running belt by pressure and try your best to make the running belt stop. If
running belt stops, together with the front roll, but the motor still runs, under this condition, it means the poly V-belt needs to be
adjusted.
c) Turn the speed to be around 3km/h, step on the running belt by pressure and try your best to make the running belt stop. If
running belt stops, but front roll still runs, under this condition, it means the running belt needs to be adjusted.
The adjustment steps for poly V-belt
a) Unplug all power supply and take off the base cover.
b) Loosen the four screws for the motor, adjust the V-belt tension bolts in clockwise direction, and then tighten back the four
screws for the motor.
Adjustment running belt
a) Turn the speed to be 6km/h. for running
b) Turn the both tension screws located at the end of the treadmill on the right and left sides, half a turn clockwise using the Allen
key. (Diagram1 and Diagram 2)
c) After adjustment, running belt still slips; please repeat the steps as above.
d)
Tighten the running belt (Diagram 1) Loosen the running belt (Diagram 2)
The adjustment steps for running belt deflection
The running belt will be deflected more or less under using. Then it needs to be adjusted. The steps are as follows:
a)
Place the treadmill on a horizontal floor, turn the speed to be 6 km/h for running.
b) If the running belt is deflected to the right, adjust the bolt on the right by turning it for half a turn clockwise, then adj ust the bolt
on the left by turning it half an anti-clockwise.(see Diagram 3)
c) If the running belt is deflected to the left, adjust the bolt on the left by turning it for half a turn clockwise, then adjust the bolt on
the right by turning it half a turn anti-clockwise.(see Diagram 4)
d) After the adjustment, the running belt still keeps deflecting , please repeat the steps above.
running belt deflected to right running belt deflected to left
The adjustment for right deflection (Diagram 3) The adjustment for left deflection (Diagram 4)
Running board lubrication- Silicone oil has been provided (White Bottle)
The treadmill is brand-new and has been pre-factory lubricated. Lubrication is not necessary directly after purchase.
Lubrication needs constant maintenance termly after purchase. The friction between the running board and running belt has a great
effect on the treadmills’ life. So please lubricate your machine termly(every one month). The steps are as follows:
Step 1. Please unplug power supply for the treadmill and loosen the belt(Belt tension screw located at the end of the treadmill).
Step 2. After loosening the screw, lift up the running belt and clean in-between the running board. Squeeze the small white bottle of
SILICONE oil which was supplied with your purchase and wipe it evenly across the board.
Step 3. After lubricating the board, screw the belt tension back to its correct tension. Tighten evenly on both sides. When it is
almost tensioned, run the treadmill at 1km without any load. Adjust both tension screws to make the belt in the centre of the back
roller. Run the treadmill at 5km for 3mins.
Step 4.
Stop the treadmill and start to walk on it at 5km/h. Lastly fine tension both screws until it’s running smoothly with your
weight on.