4.3. Cabling
Before You Begin
NOTE
When using Easy Config Modes, the Bolt Serial that is to be configured as
a Client does not need to be connected to the Ethernet wires. Only power
and Serial wiring are used.
NOTE
To maintain signal integrity, low emission and high immunity to EMI,
untwist the twisted pair cable as little as possible.
Procedure
Create connector cable for Bolt Serial
1. Cut off one of the connectors on a standard Cat5e or Cat6 Ethernet cable.
2. Strip off about 40 mm (1½ inch) of the cable jacket and untwist the orange, orange/
white, green and green/white wires.
The shield and the other wires are not used.
3. Strip off about 7 mm (¼ inch) of the isolation on each wire.
4. Push the pin spring release next to each socket on the connector and insert the
correct wire end according to
Cabling
Anybus
®
Wireless Bolt Serial
™
SP2554 2.0
Page 11 of 28
