4.2. Connector
The 18-pin connector is common for several models of the Anybus Wireless Bolt. Some
pins may have a different function depending on model. Unused pins should not be
connected.
Figure 2. 18-Pin connector
The location of the RESET button can be used as a reference for the pin numbering when
the connector is attached to the Bolt Serial. Pin 1 will be the pin closest to the RESET
button.
NOTE
The Ethernet interface is intended for configuration purposes only. Bolt
Serial is not designed for permanent Ethernet communication.
NOTE
A and B marking differs between different devices, in this product A is
TX-/RX- or D- and B is TX+/RX+ or D+.
Pin
Name
Description
1
VIN
Power + (9–30 V)
2
GND
Power Ground
3
DI
Digital input + (9–30 V)
4
DI_GND
Digital input ground
5
Ethernet r (white/orange)
Connector
Anybus
®
Wireless Bolt Serial
™
SP2554 2.0
Page 9 of 28
