HME 6700HD, Руководство по установке

Страница: 34 / 68

EQUIPMENT INST
ALLA
TION
27
Accessing the Bridge with Ethernet
1. Connect all System 485 devices and power ON, but
DO NOT
connect the 485 to the bridge yet.
2. Connect all the network cables to bases and bridge, connect them to the network switch but
DO NOT
power on the bases at this time.
3. Connect the laptop to the HME network switch via a network (CAT5) cable. This should be the
same network switch connecting the Sonic Bridge and base stations.
4. Configure the laptop IP address to communicate with the Sonic Bridge. The recommended
address that should be used for the laptop is 10.xx.xx.55. The Bridge IP address is
10.xx.xx.2
,
where the middle two octets are the store number (Ex:
Store 1392
has the address
10.13.92.2
).
Refer to label on front of the bridge.
5. Configure the “Subnet mask” for the laptop to be
255.255.255.128
. The “Default Gateway”
should be left blank.
6. Go to
Bridge Power Up
(next page) to continue setup.
Sections
1 2 3 4 5 6 7 8 9 10 11 12