HME 6700HD, Руководство по установке

Страница: 9 / 68

ST
AND
ARD EQUIPMENT
2
2. STANDARD EQUIPMENT
These instructions are for installation of standard SYS6700HD equipment and most commonly used
optional equipment. Specific instructions may also be enclosed with optional equipment.
IMPORTANT! If you haven’t already done so, before proceeding with the installation, set up the battery
charger and plug it into an AC electrical outlet, and charge all the batteries in it while other equipment is
being installed. Refer to Section 3.
Standard installation of the SYS6700HD consists of installing Routers, Bridge, Base Stations and Consoles
inside the building. Ceiling Speakers may also require installation. Outside in the drive-thru area,
speakers/microphones must be connected via cables to Routers inside the building. Cables may already
be in place, but may need to be pulled in some cases.
A vehicle detector may need to be installed in a drive-thru lane. Wiring of all units, various adjustments
and DIP switch settings, as well as equipment setups will be required.
After all the equipment is installed and set up, an operational check must be done. Last, and of utmost
importance, a SYS6700HD training/orientation session will be required for store personnel.
Approximately three nights are standard with two people for installation of the SYS6700HD.
Before installing the system, coordinate the time of installation with the store owner/manager to minimize
disruption of business.
As you unpack the SYS6700HD, check the packing list for each item to verify receipt of all equipment
listed.
Sections
1 2 3 4 5 6 7 8 9 10 11 12