19
o
4 6
Register Speaker Stations
The first time you operate a Speaker Station, you must register it for use with a specific Base Station. The Base
Station will then recognize the Speaker Station when its power is on, and will be able to tell the difference between
it and other electronic equipment operating on similar frequencies, or DX family Beltpacs or All-in-one Headsets.
NOTE:
The Speaker Station must be within 6 feet (1.83 meters) of the Base Station while being registered.
Registration Procedure:
•
Be sure the Speaker Station is turned off and the Base Station power is on.
•
On the Base Station, press and release the
REG
button (
#6
).
⎯
The
STATUS
display (
#4
) will show a small “
o
” for open.
•
On the Speaker Station, press and hold the
ISO
button while you press and release the
POWER
button to turn
the unit on, and then release the
ISO
button. This will cause the Speaker Station to enter the registration mode.
⎯
The
STATUS
display on the Base Station will continue to show a small “
o
.”
⎯
The
ISO
and
IC
lights on the Speaker Station will be blinking red then will change to a steady green
IC
light.
If registration is successfully completed:
•
If you have a headset plugged into the Speaker Station or if the speaker is on, you will hear a voice
message in the headset or speaker saying “Power on, Speaker #, Version #, Begin registration,
Registration complete…”
•
After a delay of up to 15 seconds, the
STATUS
display on the Base Station will show the ID number
assigned to the Speaker Station, for about 10 seconds.
NOTE:
ID numbers are assigned sequentially to registered COMMUNICATOR
®
s as 0 thru 3.
•
The
IC
light on the Speaker Station will remain on steady green.
IC
button
and light
ISO
button
and light
