20
If registration failed:
•
A voice message will say “Power on, Speaker, Version #, Begin registration, …”
The
ISO
and
IC
lights on the Speaker Statio n will be blinking red, and there may be a delay of up to
90 seconds before you hear “Registration failed,” and the
STATUS
display (#
4
) goes blank.
•
Press
RESET
(#
7
) on the Base Station. To press
RESET
, insert a small paper clip or similar object
into the
RESET
hole at the lower-left corner of the Base Station front panel. When the
STATUS
display (#
4
) becomes blank, press the
REG
button (#
6
) on the Base Station and register the Speaker
Station again. If registration fails again, call your dealer for assistance.
If you try to register more than 4 COMMUNICATOR
®
s to a Base Station:
•
An “
F
” (for registration “Full”) will appear on the Base Station
STATUS
display (#
4
), and you will
hear “Registration failed.”
•
Clear all current registrations by pressing the
CLR/BND
button (#
5
) and
RESET
(#
7
) on the Base
Station at the same time. To press
RESET
, insert a small paper clip or similar object into the
RESET
hole at the lower-left corner of the Base Station front panel. Continue holding the
CLR/BND
button
after you release
RESET
, until the clear code “
c
” (lower case) appears on the
STATUS
display.
•
Register all active Speaker Stations, one at a time.
4 6
7
5
F
c
