9
Step 2.
Connect power -
•
Plug the connector at the end of the AC power supply cord into the
12-14VDC
power connector
on the rear panel of the Base Station, and turn the nut on the connector clockwise to secure it to
the Base Station.
•
Plug the female connector at one end of the power cord into the AC power supply, and plug the
other end into an electrical outlet.
•
Press the
POWER
button
on the front of the Base Station to turn it on. The red light above the
button should go on.
Step 3.
Charge batteries -
IMPORTANT!
– Before using the DX121 system, charge the batteries for the Beltpacs and/or
WH200 Headsets. Charging time for fully-discharged batteries is about 3 hours per battery.
•
One battery can be charged in the battery charger at a time.
•
Insert a battery in the charging port until it clicks in place.
•
A red charging
CHG
light above the battery port stays on while a battery in the port is charging.
•
A green ready
RDY
light above the battery port goes on when a battery in the port is fully
charged.
Battery
Red battery-
charging light
Green battery-
ready light
Base Station rear panel
Power cord
connector
AC power supply Power cord
Power supply
connector
To electrical
outlet
