14
If registration is successfully completed:
•
A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, Registration
complete, …”
•
After a delay of up to 15 seconds, the
STATUS
display will show the ID number assigned to this Beltpac for
about 10 seconds.
NOTE:
ID numbers are assigned sequentially as 0 thru 3.
•
The power light on the Beltpac, next to the
IC
button, will remain on steady green.
•
Repeat Steps 1 to 3 at the bottom of page 13 for each Beltpac to be registered.
If registration failed:
•
A voice message in the headset will say “Power on, Beltpac #, Version #, Begin registration, …” Both
power lights on the Beltpac will be blinking red, and there may be a delay of up to 90 seconds before you
hear “Registration failed” and the
STATUS
display (#
4
) goes blank.
•
Press
RESET
(#
7
) on the Base Station. To press
RESET
, insert a small paper clip or similar object into
the
RESET
hole at the lower-left corner of the Base Station front panel. When the
STATUS
display (#
4
)
becomes blank, press the
REG
button (#
6
) and register the Beltpac again. If registration fails again, call
your dealer for assistance.
If you try to register more than 4 COMMUNICATOR
®
s to a Base Station
:
•
An “
F
” (for registration “Full”) will appear on the
STATUS
display (#
4
) on the Base Station and you will
hear “Registration failed” in the Headset.
•
Clear all current registrations by pressing the
CLR/BND
button (#
5
) and
RESET
(#
7
) at the same time. To
press
RESET
, insert a small paper clip or similar object into the
RESET
hole at the lower-left corner of the
Base Station front panel. Continue holding the
CLR/BND
button after you release
RESET
, until the clear
code “
c
” (lower case) appears on the
STATUS
display.
•
Register all active Beltpacs, one at a time.
4 6
7
5
F
c
