MAINTENANCE
7-65
Clean and Replace Air Cleaner Element
Clean --- every 250 hours (clog may be detected even
before that)
Replace --- after cleaning six times or after one year.
Air cleaner (1) is comprised of double elements, the outer
element (6) and inner element (5). Cleaning is of outer
element (6), so do not remove inner element (5).
1. Park the machine following the same procedure as
described on page 7-7 for preparation of inspection/
maintenance work.
IMPORTANT: Take care not to allow foreign matter such
as dirt to enter the engine when cleaning or replacing
elements.
2. Loosen clip band (3) and remove dust cap (2). Clean off
dust inside the cap.
d
CAUTION: Wear goggles or safety glasses when using
compressed air [less than 0.69 MPa (7 kgf/cm
2
, 97.2
psi)].
IMPORTANT: To clean elements (5) (6), avoid giving
shocks or striking element with other objects.
3. Clean outer element (6) by blowing compressed air [less
than 0.69 MPa (7 kgf/cm
2
, 97.2 psi)] outward from the
inside of the filter element. Keep the air nozzle at least
50 mm away from the element when blowing on it with
compressed air. After cleaning, be sure to check element
(6) for any damage. If any damage is found, replace the
element with a new one.
4. Reset the dust indicator after cleaning.
IMPORTANT: Do not reuse inner element (5).
5. If the centre (clear part) of the dust indicator becomes
red right after cleaning, even though outer element (6)
has only been cleaned fewer than 6 times, replace both
outer (6) and inner (5) elements with new ones.
6. Install dust cap (2) in the original position so that arrow
marks (4) (
TOP
) point upward.
7. After cleaning, run the engine at low-speed and make
sure clogging is not detected.
M4FC-07-037
4
4
MNSC-07-018
MNSC-07-019
1
2
3
6
5
Содержание ZW 120-6
