Hitachi PC-ALHP1, Инструкция по установке и эксплуатации

Страница: 16 / 24

5.5 TIMER SETTING METHOD
Function
This function is used to start or stop the unit operation at the
setting time.
The timer setting is available for “ON TIME” and “OFF TIME”.
• ON TIME: The operation is started after the set time is pas
-
sed.
• OFF TIME: The operation is stopped after the set time is pas -
sed.
Press “ON TIME” or “OFF TIME”. By repeatedly pressing “ON
TIME” or “OFF TIME”, the indication of setting time is changed.
The setting time is available at half hour intervals up to 10 hours
and at one hour interval up to 23 hours after 10 hours.
COOL
ON
TIMER
The setting time for “ON TIMER”
is set to 6 hours.
Flashing
Function
Automatic cooling/heating operation is automatically switched
cooling and heating based on the set temperature as following
inlet air temperature conditions.
The cooling operation is performed when the inlet air temperature
is approximately 3ºC higher than set temperature.
The heating operation is performed when the inlet air temperatu
-
re is approximately 3ºC lower than set temperature.
N O T E
• If the fan speed is set to “LOW” during the heating operation,
the operation tends to be stopped by activating the protection
devices, etc. In this case, set to “MED”, “HIGH” or “HIGH 2”.
• The heating operation is not available when the ambient tem-
perature is higher than approximately 21ºC.
• The threshold of switching temperature against the setting
temperature is ± 3ºC in case of using this function. Therefore,
this function should not be utilized in the room where the ac-
curate temperature and humidity controls are required.
Start operation
Press and hold the “MODE” switch for more than 3 seconds.
The indication “AUTO” (automatic cooling/heating operation) will
appear.
AUTO
“AUTO” is set
The indications of setting temperature, fan speed and air flow
angle are turned ON depending on the condition of control.
N O T E
• The automatic cooling/heating operation is required other set-
ting. Contact your distributor and contractor for details.
• When the “MODE” switch is pressed at “AUTO”, the fan ope-
ration is started.
Point the transmitter towards the receiver kit and press “RUN/
STOP” switch. When the transmitting indication “
“ flashes,
the “ ” lamp (yellow) on the receiver will be turned on briefly.
The RUN indicator (red) on receiver is turned ON and the opera -
tion is started.
AUTO
°C
Me
The indications of setting temperature, fan
speed and air flow angle are turned ON.
Temperature, fan speed and air flow direction setting
To set the temperature, fan speed and air flow direction, refer to
the item Setting Method .
Stop operation
Point the transmitter towards the receiver kit and press “RUN/
STOP” switch again. The RUN indicator (red) of receiver is turned
OFF and the operation is stopped.
AUTO
The indications of setting temperature, fan speed and air flow
angle are turned OFF.
8 PMML0314A rev.0 - 09/2013 - P5415315
Operation