●
On-screen message descriptions 9-8
No.
Message
Meaning of message
Remedy
42
Ink Drop Charge
Too High
The charge sensor detects a high drop
charge.
●
Clean the gutter, deflection
electrode, and its
surroundings.
●
Adjust the ink pressure.
( Technical manual 6.9)
●
Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.10)
●
Check that the ink stream is
correctly retracted.
●
Please confirm the operation
of Circulation system.
(applied UX-E only)
( Technical manual 6.15)
43
Barcode Short On
Numbers
The number of characters for the selected
barcode type is insufficient.
●
Configure the number of
( 4.8.5) characters for
barcode to appropriate value.
( Technical manual 9)
44 Shutdown Fault
The shutdown process failed.
●
Turn the printer power OFF by
main switch.
Contact your nearest local
distributor.
45 Count Overflow
The calculation result of the count
multiplier overflowed.
●
Change the count multiplier
setting.
46
Invalid Data
Change Timing
A print operation was requested while the
print data was being changed.
●
Change of either data change
or print start.
47
Invalid Count Data
Change Timing
A print operation was requested while the
print data was being changed.
●
Change of either data change
or print start.
48
Invalid Print Start
Timing
The print target detection signal for the next
target arrived during the data was being
changed.
●
Change of either data change
or print start.
49 Print Overlap Fault
The print target detecter signal for the next
target arrived during the print operation for
the current target.
●
Increase the spacing between
products.
●
If the target signal is
chattering, use sensor filter
setting. ( 4.14.1).
50
Print Head Cover
Open
The print head cover is open.
●
Remove the cover and then
hit the Clear key.
●
If a magnetic substance is
used to fix the cover,
it must be replaced with
nonmagnetic resin (metal).
51
Detector Position
Improper
The print target detecter signal turned OFF
before print start during printing at repeat
print setting.
●
Move the print target detecter
closer to the print head.
●
If the target signal is
chattering, use sensor filter
setting.
●
Check the data entered.
