Hitachi HadaCrie CM-N58000BF, Инструкция по эксплуатации

Страница: 8 / 39

-4-
Level Indicator Lamp
[ L ] LOW (green): [ M ] MEDIUM (green):
[ H ] HIGH (red)
When the power switch is switched to
“On,” the lamp indicating “HIGH,”
“MEDIUM,” or “LOW” is turned on.
Level Switch Button
Every time the button is pressed, "the
strength" of the electrical potential will
change. There will be no change in
vibration strength.
Body Socket
Instrument Plug
Cord
Accessories
Rings (two) : Rings for attaching cotton.
Names of Parts and Their Functions (Fig. 1)
Body
Heating Dimple Head (titanium material)
The device vibrates while being used in
modes other than “Cool.”
Mode Indicator Lamp
Mode Switch Button
Every time the button is pressed, the
mode for use will be switched.
Power Switch (" ")
Turn on the power switch, and it will turn
"On." Press it again, and it will turn "Off."
An automatic shutoff function is equipped,
so if the device is not used for around 3
minutes, it will automatically turn "Off."
Buzzer (Switching sound/ready
sound/warning sound/abnormality
detection sound/finish sound
/
indicating timer sound)
Every time the switch or button is
pressed, the switching sound will beep.
When the preparation is completed in
“Cool” mode, the ready sound will beep.
The warning sound will beep to indicate
the continuous use of “Cool” mode.
In the event of a failure, an abnormality
detection sound will beep. When each
mode is finished, the finish sound will
beep.
Power Adaptor
Model: KH-155B
Power Plug
Cooling Head (aluminum material)
Apply this head to your skin in “Cool”
mode.
Back Plate (titanium material)
Touch this part and apply the heating
head to your skin in modes other than
“Cool,” and the device will start to
operate.
It will not vibrate if you remove
your hand from this plate.
Mode During preparation
Orange lamp
flashing
Orange lamp
lights
HOT MASK
COOL
Blue lamp flashing
During use
Blue lamp lights
HOT CLEANSING
HOT MOISTURIZE
Preparation Before Use
●
●
How to Charge
1. Turn off the switch, and connect the power adaptor to the main body and electric outlet.
(Fig. 2)
Since this is not fully initially charged, charge before first use.
Make sure to use only 100-240V and use the included power adaptor.
Do not insert and remove the power plug from an electric outlet with
wet hands. (Cause of electric shocks and short-circuits)
Do not use in places splashed with water, such as in a bath,
or in damp places. (Cause of failures or short-circuits)
Charge indicator lamp
During charge : The lamp turns on. (Red)
After charging is completed : The lamp turns off.
Charge Indicator Lamp
Lights in red when charging and turns
off after charging is completed. Flashing in
red is a signal requesting a charge.
Battery (built-in)
Lithiumion battery 1 pc.
Protective Cap
Spot Sensor
The sensor senses a spot and indicates
it by the vibration strength (Low, High).
It does not sense a spot when cotton is
attached.