Hitachi HadaCrie CM-N58000BF, Инструкция по эксплуатации, Страница: 12 / 39

-8-
●
●
●
●
How to Use
●
●
Use after removing the protective cap.
After the power switch is switched to “On,” the heating dimple head warms slowly.
2 Press the power switch. (Fig. 7)
3 Choose "the strength" of electrical potential with the level switch button.
Switch the "strength" with the level switch button according to the condition of your skin.
●
●
The level indicator lamp will be turned on, and “HOT CLEANSING” on the mode
indicator lamp will start flashing. If a lamp in another mode is flashing, press the mode
switch button to switch to “HOT CLEANSING.”
Every time the level indicator button is pressed, the “L”,”M” and “H” of the electrical
potential will be switched. There will be no change in vibration strength.
●
Make sure to hold the body with your hand touching the back plate. ●
●
●
5 Apply cotton to the skin and move the device slowly. (Fig. 9)
The mode indicator lamp will turn on and the device will start to vibrate.
The time for use is within approximate 3 minutes.
4 Hold the device with your hand touching the back plate of the body. (Fig. 8)
Step 1
"HOT CLEANSING"
This mode removes fine residue remaining in pores which cannot be removed by simple
washing.
1 Saturate cotton attached to the body with toner after washing your face.
Please use your regular toner or rubbing-off toner with an exfoliating effect.
(Do not use milky lotion or a gel-like or thick toner.)
Saturate the cotton with toner to the extent that toner permeates the back of the
cotton.
●
Do not use the product around eyes and ears.
(Cause of accidents or bad physical condition)
If you feel something is unusual with your skin or body while using the
device, stop using it immediately and consult a skin care specialist.
(Cause of accident or poor health)
Some toner (just with mineral spring or water) may be difficult to bring out a
good effect.
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "L."
Weekly Full Course (Required time: approximate 11 minutes)
Step 1 "HOT CLEANSING"
Step 2 "HOT MOISTURIZE"
Step 3 “HOT MASK” (use of sheet mask)
Step 4 “COOL”
Care for your skin once or twice a week by using all modes.
Fine vibrations in “Hot Mask (use of sheet mask)” mode and gentle switching of the
electrode will condition the skin.
Tighten your skin by cooling effect in “Cool.”
This device will not operate with the power adaptor plugged into an outlet.
Remove the power plug of the power adaptor from the outlet to use.
The memory function memorizes the "strength" when the power has been turned off.