Hitachi HadaCrie CM-N58000BF, Инструкция по эксплуатации, Страница: 20 / 39

How to remove the lithium ion battery
Do not allow the (
＋
) and (
−
) terminals of the removed lithium ion
battery to make contact. (Cause of a short circuit or burns)
1. Hold the power switch and level switch buttons simultaneously for 5 seconds or more, and
all indicator lamps light and then the mode and level indicator lamps light sequentially.
Leave it until they turn off.
2. Remove the three screw concealing pieces and the three screws on the back of the body.
(Fig.16)
3. Insert a flatblade screwdriver etc., into the gap between the body cases (front) and (rear),
and remove the body case (rear). (Fig.17)
4. Disconnect the lithium ion battery connector, and take it out of the battery holder. (Fig.18)
Screw concealing piece Screw
Flatblade screwdriver
Body case (rear)
Body case (front) Connector Battery holder
-16-
CAUTION
Make sure to pull out the device plug from the main body after charging.
Do not store it when the power adaptor is connected with the main body or the cord is
wound around the main body.
(Result in damage of the cord)
Cord
Do not wind the cord around
the main body.
Device plug.
※
Make sure to pull out the device plug
from the main body after charging.
(Make sure to holding the plug to pull
out from main body.)
Do not keep the device plug and cord in a state of bending.