Hitachi HadaCrie CM-N58000BF, Инструкция по эксплуатации

Страница: 15 / 39

-11-
●
3 Choose "the strength" of electrical potential with the level switch button.
Switch the "strength" with the Level switch button according to the condition of your skin.
Every time the level indicator button is pressed, the “L”,”M” and “H” of the electrical
potential will be switched. There will be no change in vibration strength.
●
2 Press the power switch. (Fig.10)
When the "HOT CLEANSING" mode is finished, press the power switch and the
"HOT MOISTURIZE" mode will automatically be set.
The mode indicator lamp will switch and turn on, and the device will start to vibrate.
The time for use is within 3 minutes.
●
●
●
●
Add more toner or moisturizing product when the heating dimple head does not
easily slide.
Apply the heating dimple head gently to the face and slowly move the device by
sliding it from the center of the face to the outer side.
Unless you apply the heating dimple head to your skin while touching the back plate,
the device will not vibrate. (skin sensing function)
If the heating dimple head is not vibrating, the device is not working.
If you leave the device as it is for about 3 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
5 Apply the heating dimple head to the skin directly and move it slowly. (Fig. 9)
CAUTION
4 Hold the device with your hand touching the back plate of the body. (Fig. 8)
● Make sure to hold the body with your hand touching the back plate.
1 Apply a gel-like moisturizing product or thick toner that you would normally use onto the
heating dimple head and smoothen it over the entire head with your fingers. (Fig. 11)
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "L."
Moisturizing product
Do not keep the heating dimple head on the same area of skin, it is
necessary to move it around.
(Cause of problems with your skin or physical discomfort.)
Skin care time is indicated by the buzzer beeping about every 45 seconds as a guide.
[Example of skin care sequence] (Fig. 9)
Divide the area from your face to décolletage into four zones as shown in the
illustration. By moving the heating dimple head in the order of
①②
%RWKFKHHNVĺ
③ 7]RQHĺ ④
décolletage, the whole area can be efficiently and uniformly cared for.
Indicating Timer Function
The level indicator lamp will be turned on, and “HOT MOISTURIZE” on the mode
indicator lamp will start flashing. If a lamp in another mode is flashing, press the mode
switch button to switch to “HOT MOISTURIZE.”
●
The memory function memorizes the "strength" when the power has been shut off.
Spot
Vibration
Dark
Low High
Light
SPOT SENSOR
It senses a spot and indicates it by the vibration strength (Low, High).
The vibration changes in stages to indicate the spot.
※
Also the sensor responds to dark-colored areas
such as moles, shadows and bruises.
Do not directly look at the spot sensor because its light is extremely bright.
The spot sensor senses a spot only when the heating dimple head is working.