K6610007
Rev.5
02.14.’03
- 30 -
Table 6.2 Signal List(3/3)
Signal name
Pin
I/O type
Description
DASP-
39
I/O
This signal indicates that a device is active or that Drive 1 is present
when the power is turned on.
Upon receipt of a command from the host, the device asserts this
signal. At command completion, the device de-asserts this signal.
DMARQ
21
O
The device shall assert this signal, used for DMA data transfers
between host and device, when it is ready to transfer data.
DMACK-
29
I
The host in response to DMARQ to either acknowledge that data
has been accepted, or that data is available shall use this signal.
JUMPER0,1,2 PIN-A,B,D
-
See
Sec. 4.3 “ Drive Address Setting (Drive 0/Drive 1)” for the detail.
The I/O signal levels are as follows.
(1) Input signal High level
+
2.0V to Vcc
+
0.5V
Low level
−
0.5V to
+
0.8V
(2) Output signal High level
+
2.4V to
+
5.25V or an open circuit
Low level
+
0.4V or less (IOL=2mA),
+
0.5V or less (IOL=12mA)
Note) The I/F cable should be no longer than 50cm(20 inches) including the circuit pattern length in the host
system. If the cable length is not within this specification, it may cause factional degradations or some
errors.
