![background image](http://html.mh-extra.com/html/hitachi/cm-75eap/cm-75eap_service-manual_140826019.webp)
-18-
• Water supplier
10. Disassembly and reassembly of the muffler
[Tools required]
• Hex. bar wrench (5 mm)
• Phillips screwdriver
(1) Disassembly
• Remove the two Bolts M6 x 20
[126]
and two Bolts
M6 x 50
[123]
by using a hex. bar wrench (5 mm),
and then remove the Muffler
[124]
and Heat
Protection Plate
[125]
.
• Remove the two Machine Screws M4 x 12
[127]
by
using a Phillips screwdriver, and then remove the
Exhaust Gasket
[129]
and Exhaust Pipe
[128]
.
(2) Cleaning of exhaust ports
• Use steel wire to remove carbon dust in the
exhaust ports of the Cylinder
[146]
and Muffler
[124]
, as well as in the Exhaust Pipe
[128]
, and
then use compressed air to blow the parts clean.
NOTE: Be careful not to let any carbon dust into the cylinder, and be careful not to damage the
Heat Protection Plate [125]
.
(3) Reassembly
Reassembly can be conducted by reversing the disassembly procedure. However, special attention
should be given to the following items.
• Degrease the threaded holes of the Cylinder
[146]
, Crank Case (A)
[6]
, and Crank Case (B)
[44]
before remounting the Muffler
[124]
.
• Temporarily secure the Muffler
[124]
with the two Bolts M6 x 20
[126]
and two Bolts M6 x 50
[123]
,
and then firmly tighten all the bolts.
• Do not reuse the Bolts M6 x 20
[126]
and Bolts M6 x 50
[123]
.
11. Disassembly and reassembly of the water supplier
[Tools required]
• Hex. bar wrench (5 mm)
•
Socket wrench (19 mm)
(1) Disassembly
• Loosen the Lock Nut
[75]
and pull out the Water Supply Hose
[76]
. Loosen the Water Supply
Connector
[174]
by using a socket wrench (19 mm) and remove the Valve
[176]
and Coupler
[177]
from the Mounting Plate
[175]
.
(2) Reassembly
Reassembly can be conducted by reversing the disassembly procedure. However, special attention
should be given to the following items.
• Be careful not to bend the Water Supply Hose
[76]
.
• Firmly insert the Water Supply Hose
[76]
into the Water Supply Connector
[174]
until it contacts the end.
• Gradually increase the tightening torque of the Coupler
[177]
to prevent radial protrusion of the O-ring.
[129]
• Muffler
[124]
[125]
[123]
[126]
[128]
[127]
[6]
[44]
[146]
[76]
[75]
[174]
[175]
[176]
[177]
[118]
O-ring