Hitachi C28W440N, Руководство пользователя

Страница: 10 / 22

GB - 9 -
Before Switching on your TV
Power connection
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambient
room temperature before you connect the set to the
mains.
Aerial Connections
• Connect the aerial plug to the aerial input socket lo-
cated at the back of the TV.
How to connect other devices
IMPORTANT: Switch off the TV before connecting any
external device.
Sockets for external connections are on the back of the
TV.
For connection of other devices via SCART connector
(or RCA Jack) refer to the manuals of the related de-
vices.
Inserting batteries in the remote control
handset
• Remove the battery cover located on the back of the
handset by gently sliding it in the direction shown be-
low.
• Insert two MN2400 AAA or equivalent type batteries
inside.
• Replace the battery cover.
Note: Remove the batteries from the remote control
handset when it is not going to be used for a long time.
Otherwise it could be damaged if the batteries leak.
Switching the TV ON/OFF
You can operate your TV either using the remote
control handset or directly using the buttons on
the TV.
To switch the TV on
Your TV will switch on in two steps:
1- Press the power button located on the front of the TV.
Then the TV switches itself to standby mode and the
RED LED located below the TV turns on.
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a pro-
gramme number is selected,
or,
Press Programme Up and Down buttons on the front of
the TV or on the remote control respectively, so the TV
will switch on and the RED Led will turn GREEN.
To switch the TV off
• Press the stand-by button on the remote control, so
the TV will switch to stand-by mode and the GREEN
LED will become RED, or,
• Press the power button located on the front of the
TV.
Operating the TV
You can operate your TV in two ways. First by using
the remote control handset and second by using
the controls on the TV.
APS (Automatic Programming System)
T h e A u t o p r o g r a m m i n g s y s t e m a u t o m a t i c a l l y
programmes your TV according to the correct transmis-
sion system in your area.
When you turn on your TV for the first time, the "Auto
Setup'' menu will be displayed. In this menu if the lan-
guage setting is incorrect, use either “
“ or “ ” but-
tons to highlight "Language'' and select the most suit-
able language using the “
“ or “ ” buttons. Then use
either of the “ “ or “ ” buttons to highlight "Country".
If the country setting is incorrect, use either of the “ “
or “ ” buttons to select the correct one. Finally use
“ “ or “ ” buttons to highlight " Start" and press ei-
ther of the “ “ or “ ” buttons to start the "Auto-Pro-
gramming''. The "Auto-Programming system'' (APS)
can be cancelled by pressing the "TV'' button located on
the remote control handset.
When the APS has finished a table of stored stations will
be displayed on the screen with number 1 highlighted in
red. In the table you will see programme numbers and
names assigned to the stations, they will be listed in a
predetermined order.