Hitachi C11XM25, Руководство по обслуживанию

Страница: 31 / 72

31
CP-X444(C11XMB)/CP-X440(C11XM25)
Wiring diagram 2
Wiring of the power supply unit (when assembling the power supply block SUB ASS’Y)
(1) Wire the CNPW1, TSW (lamp temperature
switch), and #6800 (external air temperature sensor).
(2) Connect and wire the CNPWR (3) Wire the igniter lead and AC lead (4) Wire the CNBAR Wire the CNBAR by passing it through the cut portion of the ballast’s insulation sheet, and make sure that the cables do not sag inside the power supply block (Oth- erwise,
wiring
operations
will
not
be
possible
in
the
manufacturing
process
afterwards
due
to
insufficient
wire length)
Wire
the
igniter
lead
by
passing
it
through
the
clamp of the ballast holder, and make sure that the
cables
do
not
sag
inside
the
power
supply
block
(Otherwise,
wiring
operations
will
not
be
possible in the manufacturing process afterwards due to insufficient wire length)
Wire the AC lead by passing it though the cut
portion
of
the
circuit
power
supply’s
insulation
sheet,
and
make
sure
that
the
cables do not sag inside the power supply block (Otherwise, wiring operations will not be
possible
in
the
manufacturing
process
afterwards due to insufficient wire length)
FEB3
CNBAR
CN101
CN1
CN102
CN103
CN2
AC
lead
Earth
lead
CNPWR
When connecting the CNPWR connector to the
CN1
(ballast
power
unit),
make
sure
it
locks in place completely.
It
is
OK
if
the
CNPWR
cable
falls
down
the
space
between
the
outer
surface
of
the insulation sheet and the case.
Ballast
power
unit
CN1
CNRWR cable
Insulation sheet
Circuit power unit
The TSW and #6800 cables should never sag
on
top
of
the
power
supply
board
(Otherwise,
wiring
operations
will
not
be
possible
in
the
manufacturing
process
afterwards due to insufficient wire length)
FEB4
CNPW1
#6800
TSW