85
T
rouble
shooting
Symptom
Possible cause
Solution
Door
The door does not
open.
Is the
HIGH
indicator blinking?
z
When the inside of the drum is hot due to
drying operations and warm-air spinning,
a cooling operation is used to cool the
temperature down.
Wait until the inside of the drum cools down. You
can open the door when
HIGH
turns off.
(P. 32)
Is the DOOR LOCK set?
z
The DOOR LOCK will remain set and the
door will remain locked even when the power
automatically turns off after an operation
finishes.
Release the DOOR LOCK.
(P. 33)
Is there water inside the drum?
z
Depending on the water level during the
operation, the door lock may not release.
Run a spin operation to drain the water.
Is air blowing?
z
Even if you pause the operation, the door will
not open until the airflow stops.
Wait until the airflow stops.
Is “000” blinking in the remaining time
indicator?
z
If so, Soft Guard operation is in progress.
Press the [PAUSE] button to unlock the door. For
details on the Soft Guard setting, see
(P. 69)
.
The door does not
close.
Is there an obstruction stuck between the door
lock area?
Remove any objects.
Press the right middle area of the door, and close
it completely.
z
Is the door stopper extended?
Return the door stopper to its original position.
(P. 33)
Dru
m
The drum and
drain hose are wet,
even though they
have never been
used.
z
Moisture and condensation from function tests
performed at the factory may still remain in the
drum and drain hose.
This is not a malfunction.
The color of the
drum has changed.
z
Contact with water and detergent can oxidize
and discolor the drum.
If this is a concern, wipe the drum using a
stainless steel detergent.
Powe
r
The power does
not turn on.
Is the power plug connected to a power outlet?
Connect the power plug to a power outlet.
The operation
stops or the power
turns off while in
progress.
Did a power outage occur? Did a fuse blow or a
short circuit occur?
Press the [ON] button, and restart the operation.
Is there an appliance that emits noise, such as
a television or radio, near the machine?
z
If noise continuously enters the machine, the
power will turn off.
Disconnect the power plug and reconnect it,
and then press the [ON] button and restart the
operation. Do not place televisions and radios
near the machine.
z
If the temperature of the drum rotation
motor reaches a certain level, the power is
automatically turned off for safety.
This is not a malfunction.
Wait about 1 hour before restarting the operation.
z
If you start a drying operation while the dry
filter is clogged, the power may turn off
automatically.
This is not a malfunction.
Clean the dry filter.
(P. 73, 74)
The display
does not appear
immediately after
turning on the
power.
z
The machine will beep twice when you press
the [ON] button, and the display will light about
1 second later.
This is not a malfunction.
The control board takes a few moments to
startup.
En
g
lish