INSTALLING THE SYSTEM
INSTALLING THE SYSTEM
This system consists of 6 units that need to be installed – The main unit, the woofer unit, the display unit,
the external DAB/FM rod antenna and the two speakers.
1. Link the woofer and the main unit with the 13 pin cable; insert the cable ends to the connectors located
at the back of the units with the “arrow marks” aligned.
2. Connect one end of the speaker cables to the speakers.
3. Connect the other end of the speaker cables to the speaker sockets on the main unit or on the woofer
whichever you prefer.
4. Connect the display cable to the display socket located at the back of the main unit.
5. Install (screw in) the rod antenna into the antenna base and connect the cable to the RF connector
located at the back of the main unit.
6. The installation is completed and you can now plug the woofer into the AC mains outlet.
7. To power up the system, set the Power Switch (at the back of the woofer) to on; the system will be in
standby mode, the display will first show the greeting and then the clock.
8.
the Standby button to switch on the system and now you can use the remote control to start
Press
your operation.
Note: Due to the unique design of this system, you need to use the remote control for most of the functions;
to ensure the full operation of the system, the remote unit must always be accessible and in good
working condition.
IMPORTANT NOTE: Every time you need to power off the unit via the Power Switch, you must first switch the
unit to standby mode, this is to prevent unavoidable pop sound from the speakers.
7
ANTENNA
