13
1
3
2
2
1
Please turn on the water tap to check to connecting condition of the water supply hose
before washing.
開始洗衣前，請先打開水龍頭，檢查供水管的連接狀況。
To prevent damages caused by water leakage due to loosen screw.
如果螺釘鬆脫，會因漏水而招致不必要的損失。
How to install and remove the water supply hose
Water tap
水龍頭
Do not allow water tap, one touch joint and rubber
ring to touch the unit when installing them.
安裝水龍頭、便捷連接器以及滑環時，注意別讓它們碰到
洗衣機機體。
■
Installing
安裝方法
Push down the rubber ring
and insert the tap into the
one touch joint.
將滑環下壓，然後插入便捷連
接器內。
Release the rubber ring and
push up the water supply
hose until it clicks.
放開滑環，向上推壓供水管，
直至發出“叭”的鎖緊聲為
止。
Pull the water supply hose to
check that it does not come
off easily.
拉一拉供水管，確認供水管
不會脫落。
■
Removing
拆卸方法
Turn off the water tap.
關閉水龍頭。
Press the start button and let the unit run for about
ten seconds.
按下
動按鈕，運轉
10
秒鐘。
This is to prevent water splash when removing the tap.
為了防止拆卸時水花四濺。
Remove the latch and the water supply hose while
pushing down the rubber ring.
鬆開搭扣，拉下滑環，同時將供水管拔下。
Loosely tightened union nut will cause water
leakage.
連接螺母如不擰緊，可能產生漏水現象。
When removing the hose, unscrew the union
nut first.
拆卸時，擰下連接螺母，即可拆除。
Please note that water supply hose and one
touch joint should be used.
請使用隨機配套的供水管和便捷連接器。
Turn the union nut in the direction as shown
by the arrow and firmly. Connect it to the
water supply opening.
沿箭咀方向旋轉連接螺母，使其與供水口緊緊
相連。
Firmly tighten the union nut when con-
necting the water supply hose to the main
unit.
請務必旋緊供水管與機體的連接螺母。
Failure to do so may result in water
leakage.
螺母鬆脫的話，可能會漏水。
Installation
安裝
注意
注意
Attention
Attention
供水管的安裝方法和拆卸方法
One touch joint
便捷連接器
Latch
搭扣
Latch
搭扣
Water supply hose
供水管
Rubber ring
滑環
Rubber ring
滑環
關
Turn off
Union nut
連接螺母
警告
Attention
注意
Main unit
機
體
The appliance is to be connected to the water
mains using new hose-sets and that old hose-
sets should not be reused.
應使用附帶的新的連接水管進行連接，舊的連
接水管不得再次使用。
