Hitachi 51F510, Руководство пользователя, Страница: 135 / 152

DP-4X CHASSIS RASTER POSITION ADJUSTMENT
PAGE 08-2
8
IMPORTANT:
Remote MUST BE IN Digital
Convergence Adjustment Mode .
To enter the Remote Control
into DCAM see page 08-18.
NOTE: If only minor conver-
gence adjustments are neces-
sary, the Overlay Jig is not nec-
essary. Use one color that looks
the best as the reference and
align the other two colors to that
reference.
Do not Clear Data
and Write to ROM. This would
cause a need to do a complete
Digital Convergence Alignment.
RASTER POSITION
ADJUSTMENT: (Minor)
Adjustment Preparation:
1) Position Adjustment. This
will move an entire color's
raster. Use this adjustment
to match a color with a refer-
ence color in the center of
the screen.
2) Use the following Keys to
select a color to adjust.
•
INFO : REEN
•
0 : RED
•
INPUTS :BLUE
3) RAM should be Cleared.
With Power Off, press and
hold the
Service Only
Switch on the Deflection/
Convergence PWB. Then
press the
POWER button.
Release both buttons. Set
comes on with cleared con-
vergence data. If the DCU
grid doesn't appear, press
the Service Only switch
again. Do not re-read the
Old ROM Data.
Adjustment Procedure:
1) Press the play
button.
Extra Horizontal lines
appear to confirm
Raster Position Mode.
•
Other Modes can not
be accessed in this
mode.
2) Use the Thumbstick to
adjust the entire color
selected to match the
reference color.
3) Press the play
button to exit the
Raster Position Mode.
Extra Horizontal Lines
will disappear.
DP-4X New Remote Controls. (CLU-3842WL or CLU-4341UG2) The Remotes must be placed into
*DCAM (See Instruction Page) before using them for Digital Convergence adjustments.
*
DCAM = Digital Convergence Adjustment Mode.