Hisense HWFR6510 Скачать руководство пользователя страница 6

Ensure that the ventilation openings in the base of the washing machine(if 
available on your model) are not obstructed by a carpet or other material. 

4. Install water inlet(see also separate Installation guide)  

Please refer to the Installation guide for installing the water inlet.  

5. Install Drain(see also separate Installation guide) 

Connect the drain hose to the siphon or hook it over the edge of a sink by 
means of the "U" bend supplied. 
If the washing machine is connected to an integrated drainage system, 
ensure that the 
integrated drainage system is equipped with a vent to avoid simultaneous 
loading and draining of water (siphoning effect). 
The drain plug should be removed at all time.  
Secure the drain hose tightly to prevent spills and scalding during machine 
drainage. 
The drain hoses must always be securely tighten  and remain in an 
undamaged state. 

 

6.  Install Electrical connection  

Electrical connections must be carried out by a qualified technician in 
compliance with the manufacturer's instructions and current standard safety 
regulations. 
Data regarding voltage, power consumption and protection requirements are 
given on the back of the washing machine. 
The appliance must be connected to the mains by means of a socket with an 
earthconnection in accordance with current regulations. The washing machine 
must be earthed by law. The manufacturer declines all liability for damage to 
property or injury to persons or animals due to non-compliance with the 
directions given above. 
Do not use extension leads or multiple sockets. Make sure the capacity of the 
socket is powerful enough to drive the machine during heating. 
Before any maintenance on the washing machine disconnect it from the mains 
supply. 
After installation, access to the mains plug or to disconnection from the mains 
supplymust be ensured at all times via anelectric switch. 
Do not operate the washing machine if it   has been damaged during transport. 
Inform After-Sales Service. 
Mains cable replacement is only to be carried out by AfterSales Service. 
The appliance must only be used in the household for the prescribed uses. 

BEFORE THE FIRST WASH CYCLE

 

recommend that you carry out a short wash cycle without laundry.

 

Open the tap. 
Close the door. 
Pour a little amount of detergent (about 30 ml) into the main washing chamber 
of the detergent dispenser. 
Select and start a short programme (see separate quick reference guide). 

PREPARATION OF THE WASHING

 

 

1. Sort the laundry according to ...  

Type of fabric /care label symbol

 

Cottons, mixed fibers, easy care/synthetics, wool, hand wash items. 
The wool wash cycle of this machine has been tested and approved by The 
Woolmark Company for the washing of Woolmark garments  labeled  as "machine 
wash" provided that the garments are washed according to the instructions on the 
garment label and those issued by the manufacturer of this washing machine. 

Colour 

Separate coloured and white items. Wash new colouredarticles separately. 

.

.

.

.

.

.

.
.

.

.

.

.

.

.

.

.

.

.

.

.

.

 

  

6

 

Loading 

Wash items of different sizes in the same load to improve washing efficiency and 
distribution in the drum. 

 

2.  Prepare the  cloth for washing  

Empty all pockets, coins, safety pins etc. can damage your laundry as well as 
the appliance drum and tub. 
Close the zips and fasten buttons or hooks; loose belts or ribbons should be 
tied together. 
Wash small items (e.g. nylon stockings,  belts etc.) and items with hooks (e.g. 
bras) in a cloth bag or pillow case with zip. Always remove curtain rings or 
wash curtains with the rings inside a cotton bag. 

 

3.  Adding detergents and additives  

Please refer to Section Detergent and additives.  

.

.

.

.

To remove any residual water used during testing by the manufacturer, we

5

4.  Loading the laundry  

Note: Overloading the machine will result in unsatisfactory washing 
results and creased laundry. Please be also careful when loading the 
drum with large articles. The unbalance drum could cause the 
machine vibration.   

Open the door. 
Load the articles one at a time loosely into the drum, without overfilling. 
Observe the load sizes given in the quick reference guide. 
Close the door. 

.

.

.

.

Содержание HWFR6510
















Отзывы: