This appliance is not intended for use by persons(including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children must not be allowed to play with the appliance or to climb into the
drum (see also the "Child Safety" Section).
If necessary, the power cable may be replaced with an identical one obtained
from our After-Sales Service. The power cable must only be replaced by a
qualified technician.
Do not allow children to operate, crawl on, be near or inside your washer . Now
that during the wash cycle, the surface temperature of the porthole door may
increase. Close supervision of the children is necessary when the appliance is
used near children.
5
.
Safety of opening and closing door
Only when the door opening light turns"ON" on the status bar, the door could
be opened. Never open the door forcibly while the machine is running, otherwise
you can damage the door lock.
If you must open the door while the machine is running, press the "Start/Pause"
button on the front of the control panel to pause the current cycle, and then wait for
at least 2 minutes for the door lock to be released.
To open the door, hold the door handle, press the inside handle and pull the door.
Close the door by pressing it without excessive force until it clicks shut.
Note:
In the case of power outage, please check the water level, if the water is exist in the
drum above the door level , then please drain the water from the drain hose before
opening the door,
6
.
Child safety(If Available)
To protect the appliance against improper use, turn the plastic screw on the interior of
the door. To do this, use a coin or similar objects.
Slot vertical: the door will not lock.
Slot horizontal - normal position: the door can be locked again
7
.
Safety of transport and handling
Never lift the appliance by the worktop when transporting.
Pull out the mains plug.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
Turn off the water tap.
Disconnect the inlet and drain hoses.
Drain all remaining residual water from the hoses and from the appliance (see
"Removing the Filter", "Draining Residual Water").
Fit the transport bolts (obligatory).
The machine is over 55 Kg in weight; therefore, two persons are needed to
move it.
8. Safety of Electrical Connection
Only use a socket with an earth connection.
Do not use extension leads or multi sockets.
Electric supply must be adequate for the machine's 10 A Current Rating.
Electrical connections must be made in accordance with local regulations.
The electrical power cable must be replaced exclusively by a licensed
electrician.
BEFORE USING THE WASHING MACHINE
1. Removing the packaging and inspection
After unpacking, ensure that the washing machine is undamaged. If in doubt, do
not use the washing machine. Contact After-Sales Service or your local retailer.
Check that the accessories and supplied parts are all present (see also the
separate Installation guide).
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach
of children, as they are potentially dangerous.
3
4
Never open the loading door forcibly or use it as a step.
Never open the loading door or filter while there is still water in the drum.
.
.
The washing machine is fitted with transport bolts to avoid any possible
damage to the interior part during transport. Before using the machine, it is
imperative that the transport bolts are removed.
After their removal, cover the openings with the 4 enclosed plastic caps.
.
.
2. Remove the transport bolts (see also the separate Installation guide)
3. Install the washing machine (see alsoseparate Installation guide)
Move the appliance without lifting it by the worktop.
Install the appliance on a solid and level floor surface, preferably in a corner
of the room.
Ensure that all four feet are stable and resting on the floor and then check
thatthe washing machine is perfectly level (use a spirit level).
.
.
.
