Operator’s Manual
EI65 / 0005
© PAT
Rev. C 06/15/00 // CSH
056-065 / 190005_c.doc
12
Step 12
Press Button “OK” (10) to enter the number of reevings (parts of line)
being used. If the operator wants to continue with the previously
programmed or default number of reevings, press “DOWN” (11) button.
Step 13 will be skipped, when the button “DOWN” is pressed.
Step 13
The display shows the previously programmed or default number of
reevings (parts of line). To change the parts of line, use the “UP” (12) or
“DOWN” (11) buttons. If the operator wants to continue with the
displayed number of reevings (parts of line), confirm by pressing the
“OK” (10) button.
Step 14
If you would like to review the selection made in the programming
procedure, press “OK” (10) button. The display will show jib length and
offset, check correct and press “OK”. If no jibs were selected the Exit
screen will appear.
Step 15
The Setting Procedure is completed. The crane operator has the
possibility to accept the conditions programmed on Step 1 to 13, or to
correct the values.
For correction of the preset condition press the “DOWN” (11) button and
correct the selection you have made in this programming procedure. After correcting the selection,
return to the EXIT screen to accept and exit.
Press the “OK” (10) button.
The operating screen will be displayed, which shows the measured crane data. Complete Section 5.
PRE-OPERATION INSPECTION to ensure the data shown is correct.
REEVING?
PUSH
↓
OR OK
PARTS OF LINE: 1
PUSH
↓↑
OR OK
SHOW SELECTION?
PUSH
↓
OR OK
EXIT!
PUSH
↓
OR OK
