HIOS Neji Taro II HS-35, Руководство по эксплуатации

Страница: 8 / 20

- 7 -
4-6. Checking and Adjusting the Bit Guide
Place five to ten screws in the rail and tilt this machine until
they hit the stopper on the rail assembly.
When the internal shutter is closed, the screws cannot go
through the passage plate. If it is closed, turn the timing shaft
clockwise with the Allen wrench to keep it open. The stopper
is fixed to the rail assembly. The adjustment of the stopper
is made by moving the rail assembly front and rear. If the “V”
groove on the bit guide and the rear point of the Phillips screw
head are not aligned, adjust as follows:
Loosen the bit guide mounting screw with the Allen wrench
and move the bit guide forward and back to put them in align-
ment.
Please remember to tighten the screws after adjusting.
<Replacement of the bit guide>
To change the bowl-shaped bit guide to the “V”
grooved bit guide, remove the bit guide mounting
screw and replace the guide.
5. Operating Procedures and Operational Checks
5-1. Loading the Screws
Open the screw bin lid. While the bin dipper plates are at the
lowest position, pour in the screws until they are piled up to
about 3 mm below the rail upper surface. Make sure that
screws are equally distributed into the right-and left-hand bins.
CAUTION
Do not load the screws to excess amount.
Screws
Holding plate set screw
Bit guide set screw
V slot
Holding plate
Rail set screw
Stopper
Rail ditch Rail ditch center
Bit guide
Rail
Rail
Approx. 3 mm
Bin scooper plate
Screw bin
Employ screws
Necessary adjustment when the bottom of the Phillips head of the
screw doesn’t match
Loosen the bit guide mounting screw with the Allen wrench and adjust
the position so that the “V” groove of the bit guide and the bottom of
the Phillips head of the screw match.
After making this adjustment, tighten the bit guide mounting screw.