HIOS Neji Taro II HS-35, Руководство по эксплуатации

Страница: 5 / 20

- 4 -
Be sure to turn off the power switch of the feeder
before making any adjustments.
4-2. Checking and Adjusting he Brush
Check the height of the brush. Ensure that the brush check/adjustment procedure is
completed while the brush is placed in a horizontal position as shown at right.
To place the brush in a horizontal position, rotate the timing shaft with the Allen
wrench supplied with the machine.
Please prepare the screws to be used. Drop a few of them into the rail groove,
check and adjust the brush height as directed below.
After the brush is placed in a horizontal position as shown below, rotate the brush.
When the resultant gap between tip of the brush and screw heads is approximately
0 mm, no adjustments are needed.
If any adjustment is needed, perform the following procedure:
Loosen the brush mounting screws.
Make adjustments so that the gap between tip of the brush and screw heads is
approximately 0 mm. In this instance, avoid lowering the brush too much. After
completion of adjustments, tighten the brush mounting screws.
After the brush is properly adjusted, rotate it again to verify that it
smoothly moves
without any obstruction.
Up and down adjustment
Brush set screws
Screws
Brush
Brush
Rail
No gap between the
central part of the brush
and the heads of the
screws.
Power switch