HIOS Neji Taro II HS-35, Руководство по эксплуатации

Страница: 10 / 20

- 9 -
This machine is equipped with a timer.
・ The timer setting can be adjusted according to the screw type.
Function descriptions
The actual screw feeding speed varies with screw type.
This machine continues running while there is no screw in the screw
removal area of the escaper section. It stops its operation when
a predetermined period of time elapses after a screw is retained
in the removal section. This duration of time can be adjusted with
the timer setting control on the rear of the feeder.
It is recommended that you decrease the timer setting when
the feeding speed is high, and increase the setting when the feeding
speed is slow. When adjusting the timer setting, please exercise
care and do not rotate the control beyond its permissible range.
This machine is equipped with a tilting mechanism
When the screw feeding speed is too slow, you can install this ma-
chine in a tilted position.
Descriptions
Loosen the tilt lock screws.
Pull out the base bracket from the rear of the feeder and fix it in an ap -
propriate position.
After this machine is tilted, make sure that it is steady.
Please do not tilt this machine beyond the capacity of its tilt mecha-
nism.
Decrease
Time setting
Increase
Time adjuster
Base bracket
A tilt of up to about 12 mm can be adjusted.