Hioki 2300 Smart Site, Инструкция по эксплуатации, Страница: 144 / 366

8 2321-20 WAVEFORM MODULE
131
1
2
3
4
5
6
7
8
9
APPX
IDX
*1: The module needs repair. Contact your vendor (agent) or nearest Hioki office.
*2: The same module ID may be used by another module.
POWER LED
Goes on or flashes when power is supplied to the module.
Remains on, flashes, or changes to another color according to the state of
the module.
POWER LED indication
Lit in green
: Data being recorded. (trigger waiting time)
Flashing in green : Standing by.
Lit in yellow
: TRIG.OUT output.
Lit in red : Non-recoverable error occurred.
*1
Flashing in red : Recoverable error occurred.
*2
Mark area Use this area to make a note of the object to measure or the module ID.
Use an ink pen, since pencil lead may rub off.
CH1 analog input Input voltage signal (Channel 1)
CH2 analog input Input voltage signal (Channel 2)
CHA Logic input Connect the 9320-01 or the MR9321-01 and input the logic signal.
(Channel A)
CHB Logic input Connect 9320-01 or MR9321-01 and input the logic signal.
(Channel B)
CH1 Trigger input Input trigger signal in CH1 or CHA.
CH1 Trigger output Voltage is discharged when trigger is set at CH1 or CHA.
CH2 Trigger input Input trigger signal in CH2 or CHB
CH2 Trigger output Voltage is discharged when trigger is set at CH2 or CHB.
Trigger input/output COM terminal Terminal with low electric potential common to all trigger input/output
Module ID setting dial Set IC (identification) number.