52
9. Troubleshooting
■
The diamond wire wears too quickly
Possible cause
Solution / measures
Drive speed is too low and wire cutting speed is thus also
– Increase drive speed or, respectively, cutting speed.
too low.
Inadequate cooling of the diamond wire
– Set up more water nozzles at the cutting face.
Wire cutting length too short
– Increase the cutting length (length of contact).
(length of contact between the wire and the concrete)
Wire tension too high relative to length of cut.
– Reduce the tension on the wire by adjusting the air
pressure regulation valve.
Very abrasive material being cut.
– Select a different diamond wire specification.
The direction in which the wire runs is changed continually. – Always fit the diamond wire so that it runs in the same,
specified direction.
■
The diamond wire collapses
(The diamond beads, connecting pieces and separating springs are bunched together on the wire.)
Possible cause
Solution / measures
Diamond wire not cooled adequately or not cooled at all
– Always ensure that sufficient water reaches the cutting
face.
The diamond wire becomes stuck in the kerf and stalls
– Steel wedges must be used to prevent movement of
during sawing.
the concrete sections.
– Loose fragments or aggregates must be removed from
the kerf.
Содержание DS WS15
