33
6. Preparing the saw system for use
CAUTION
Never grip the wire close to a pulley.
Your hand could be crushed and injured.
■
Align the lower hollow axle and guide pulley with the
corresponding storage pulley (observe the marking
grooves) and tighten it in this position (fig.
).
■
Check the entire course followed by the wire and read-
just any lengths of wire which may have jumped off the
■
Fit the protective cover once the wire is tensioned.
Make sure it is secured and engaged correctly. The drive
unit can be started only when the protective cover is
locked in position (fig.
).
Warning: avoid hand
injuries
Wear protective gloves
2
3
guide pulleys. Make sure that the guide pulleys on the
pulley stands are aligned with the drive unit. Exact align-
ment has been achieved when the wire runs in the cen-
tre of the guide pulleys.
■
If necessary, e.g. when an extremely soft material is
being cut, tighten the compressed air cylinder lock at
the cylinder. This prevents the wire from sticking in soft
material when the saw is started (fig.
).
5
4
Содержание DS WS15
