Hilti DS WS10, Руководство по эксплуатации

Страница: 59 / 68

10. Troubleshooting
Troubleshooting 10.1 The drive pulley / sawing wire doesn’t begin to rotate 60
10.2 The drive pulley slips / the wire is not driven 60
10.3 The wire jumps off the drive pulley or guide pulley
when starting 60
10.4 Little or no sawing progress 60
10.5 The diamond wire wears too quickly 60
10.6 The sawing wire wears unevenly / one-sided 61
10.7 The diamond wire collapses / beads are pushed together 61
10.8 The wire is pulled out of the crimped connector 61
10.9 The wire breaks immediately before or after the connector 61
10.10 The wire begins to vibrate strongly during sawing 61
10.11 The air compressor doesn’t start 62
10.12 The air compressor can’t build up pressure 62
10.13 Drive pulley speed begins to fluctuate rapidly (audible)
(DS-WS10) 62
10.14 Machine doesn’t start, green “ready” indicator lamp
doesn’t light (DS WS10-E) 62
10.15 Machine doesn’t start, green “ready” and red “fault”
indicator lamps light (DS WS10-E 62
10.16 Machine doesn’t start although green “ready” indicator lamp
lights (DS WS10-E) 62
10.17 No power at the 230V power outlet (DS WS10-E) 62
10.18 Current input is too high when idling and sawing (DS WS10-E) 63
10.19 The service indicator lights and the drive unit
may be inoperative (DS WS10-E) 63
10.20 The ground fault circuit interrupter has been tripped 63
59
Printed: 08.07.2013 | Doc-Nr: PUB / 5069736 / 000 / 01