Hilti DS WS10, Руководство по эксплуатации

Страница: 39 / 68

7. Setting up the saw system
base materials such as brittle or cracked concrete, mason-
ry and synthetic or natural stone.
WARNING
The use of vacuum base plates for fastening is not per-
missible under any circumstances.
Procedure
a) Use the template to mark the position of the anchor
hole.
b) Drill the hole, clean the hole, insert the Hilti HKD-D
anchor and expand it.
c) Screw in the clamping spindle as far as it will go.
d) Attach the positioning template to the base plate.
e) Bring the base plate into position and secure it ini-
tially with the clamping nut.
f) Align the base plate and then tighten the clamping
nut and leveling screws.
Attaching the guide rail unit
7.3
1 /
2
″
square wrench
Eccentric pin
Guide rail unit
Push the guide rail onto the connecting taper and insert
the eccentric pin fully.
Tighten the eccentric pin in a clockwise direction.
Fitting the optional storage extension
The wire storage capacity of the saw can be increased
by fitting the optionally available wire storage extension.
7.4
Fit the connecting taper and secure it with the eccentric
pin.
Push the storage extension onto the connecting taper
and secure it with the eccentric pin.
CAUTION
Use only the specified accessory components for extend-
ing storage capacity and never extend storage capac-
ity beyond the maximum permissible length of 2 meters.
1
2
3
39
Printed: 08.07.2013 | Doc-Nr: PUB / 5069736 / 000 / 01