Hilti DS WS10, Руководство по эксплуатации

Страница: 14 / 68

3. Accessories
Hilti sawing wires and accessories
Safety precautions and instructions for use
■
Use only sawing wires that comply with the require-
ments of EN 13236.
■
Connecting together lengths of wires of different
diameters, from different manufacturers or of dif-
ferent types (e.g. electroplated or sintered beads) or
use of badly worn or out-of-round wires is not per-
missible.
■
Use of damaged wires (e.g. wires with kinks, loose
or shifted beads, broken strands, etc.) is not per-
missible.
3.1
■
Observe the wire and wire connector manufacturer’s
instructions when connecting sawing wires and, as
far as possible, use only one wire connector in each
complete wire loop.
■
Use of flexible connectors greatly reduces alternat-
ing bending stresses and thus reduces the probabil-
ity of wire breakage due to fatigue.
■
Use only diamond wires with beads of a diameter
within the 8–12 mm range. Other diameters may
cause the wire to jump off the pulleys or result in
damage to the running surface of the pulleys.
Machine
DS WS10 DS WS10-E DS WS15 DS WSS30
Material
Reinforced concrete CS CM CS CM CM CH CM CH
Heavily-reinforced concrete 20 % steel 20 % steel 20 % steel 20 % steel
Reinforced concrete
dry cutting
Dry Dry Dry Dry
Steel – 100 % steel 100 % steel 100 % steel
Specification Cutting characteristics Concrete type Reinforcement content
CS Fast-cutting S: soft, soft aggregates Normal to high
Good balance between cutting
CM
speed and life
M: medium, hard aggregates Normal
CH Specially for flint, long life H: hard, very hard aggregates Normal
20 % steel Fast-cutting Universal Normal to very high
100 % steel – – Only steel
Dry – Universal Normal to high
Guidelines for the use of diamond wires
14
Printed: 08.07.2013 | Doc-Nr: PUB / 5069736 / 000 / 01