Hilti DD 150?U, Руководство пользователя

Страница: 32 / 496

24 English 2204402
*2204402*
5. Screw on the carbon brush covers on the left- and right-hand side of the motor.
6. Run in the carbon brushes by letting the machine run under no load for at least one minute without
interruption.
After replacing the carbon brushes, the display Run-in after the carbon brushes have been replaced
appears. The time bar shows the time remaining until the run-in process has been completed.
If the minimum running-in time of one minute is not observed, the life of the carbon brushes will be
greatly reduced.
8 Transport and storage
Transport
▶
Do not transport this product with an accessory tool installed.
▶
Make sure that the equipment is held securely throughout all transport operations.
▶
After transporting, always check all visible parts and controls for signs of damage and make sure that
they all function correctly.
Storage
▶
Always store this product with the electric supply cable unplugged from the electricity supply.
▶
Store this product in a dry place, where it cannot be accessed by children or unauthorized persons.
▶
After a long period of storage, always check all visible parts and controls for signs of damage and make
sure that they all function correctly.
8.1 Transport of the diamond core drilling machine
WARNING
Risk of injury! Parts can work loose and drop off.
▶
Do not lift the diamond core drilling machine and/or the drill stand by crane.
▶
Transport the diamond core drilling machine, drill stand and core bit as separate units.
▶
Use the wheel assembly (accessory) as an aid when transporting the equipment.
▶
Open the water flow regulator before stowing away the diamond core drilling machine.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 The diamond core drilling machine is not in working order
Malfunction Possible cause Action to be taken
The multifunction display is
not showing anything.
The PRCD isn’t switched on.
▶
Check that the PRCD is
functioning and switch it on.
Interruption in the electric supply.
▶
Plug in another electric tool or
appliance and check whether it
works.
▶
Check the plug connections,
supply cord, power supply line
and main supply fuse.
Water in the motor.
▶
Allow the diamond core drilling
machine to dry out completely
in a warm, dry place.
Service required.
The carbon brushes are worn out.
▶
Replace the carbon brushes.
→ page 23
Water in the motor.
▶
Allow the diamond core drilling
machine to dry out completely
in a warm, dry place.