Hilti DD 150?U, Руководство пользователя

Страница: 22 / 496

14 English 2204402
*2204402*
4 Technical data
4.1 Diamond core drilling machine
For rated voltage, rated current, frequency and/or input power, refer to the country-specific rating plate.
If the product is powered by a generator or transformer, the generator or transformer’s power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be 5 % and -15 % of the rated voltage of the device.
DD 150-U
Weight according to EPTA Procedure-01
8.4 kg
Weight of the drill stand with combination base plate and carriage 13.3 kg
Permissible water supply pressure ≤ 6 bar
Ideal distance of the mark on the anchor base plate from the hole center 267 mm
Ideal distance of the mark on the vacuum base plate from the hole center 292 mm
Ideal distance of the mark on the combination base plate from the hole
center
292 mm
Drilling depth 450 mm
4.2 Bluetooth
Frequency range 2,400 MHz …
2,483 MHz
Maximum output power 10 dBm
4.3 Working with vacuum base plate
Minimum vacuum 0.65 bar
Max. core drilling tool diameter 162 mm
4.4 Core bit diameter
1st gear 2nd gear 3rd gear
Ø core bits (stand-
guided drilling, wet)
102 mm … 162 mm 28 mm … 87 mm 12 mm … 25 mm
Ø core bits
(hand-guided)
121 mm … 162 mm 41 mm … 112 mm 8 mm … 37 mm
Ø core bits
(hand-guided dry core
bits with PCD)
52 mm … 162 mm •/• •/•
4.5 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.