32
Blade guard
■
Always ensure that the DS-BG blade guard is in place
when the saw is in operation.
■
The blade guard is in two sections to permit cutting
into corners.
■
Thanks to its symmetrical design, the blade guard can
simply be turned to permit cutting into a corner to the
left or right (or upwards and downwards) without
removing the blade from the kerf.
■
Use the 10 mm AF hex. wrench to tighten the blade
guard holder. The blade guard than always remains in
the same position.
■
Use the DS-BGF blade guard (open on one side) for flush
cutting.
Using the DS-RFP angular cutting plate
■
The angular cutting plate is used for sawing on stairs,
in tunnels and for cutting at an angle of up to 45°.
■
Align the equipment by using a protractor to measure
the angle at the blade when mounted on the saw.
■
Due to the angle of the blade, cutting depth is reduced.
The blade is also subjected to additional bending loads.
Please refer to the following table for setting-up dimen-
sions and cutting depths.
IMPORTANT:
When making angular cuts, make a shal-
low guide cut and begin cutting gently!
6.2.7
6.2.6
Angle of cut
10°
20°
30°
40°
45°
Diameter mm) 900
900
900
900
900
C (cm)
30
24
18
8
3
A (cm)
24
26
29
34
38
Flush cutting using the DS-FCA-110 flush-
cutting flange
■
As for standard sawing applications, the blade can be fit-
ted after the saw has been mounted on the rail. (Old method:
The saw and the fitted saw blade had to be lifted togeth-
er onto the rail and the saw blade guided into the kerf.)
■
The Hilti saw system can be preassembled and posi-
tioned precisely, to the millimetre.
■
The electric remote control system permits the saw
arm to be pivoted effortlessly to the height of the saw
blade mounting hole.
■
Spindle speeds and the sawing procedure are as for
standard applications.
6.2.8
DS-RFP
6. Before use
DS-BG
DS-BGF
3
4
DS-BGF
2
1
DS-FCA
Printed: 08.07.2013 | Doc-Nr: PUB / 5069667 / 000 / 01
Содержание D-LP 32
