![background image](http://html1.mh-extra.com/html/hilti/d-lp-32/d-lp-32_operating-instructions-manual_2135192038.webp)
38
Guidelines and guide values
Sawing guidelines
Please refer to the sticker on the rear of the D-RC-LP 32 remote control unit.
7.3.1
7.3
l.
ll.
lll.
lll.
ll.
l.
15 15
15
l.
ll. lll
. ....
cm
Hard
Guid
e
cm
Tmax
33
cm
800 mm
1.
Tmax
43
cm
1000 mm
2.
Tmax
53
cm
1200 mm
3.
Tmax
73
cm
1600 mm
3
5
6
7
5
1
/8
4.
80
0
10
0
10
00
95
12
00
85
16
00
80
(m
m)
l/m
in
Soft
5
4 10
10 10
7. Operation
See description: section 2.3.4, page 10.
The guide cut
The initial cut, known as the guide cut, must always be
made with the saw arm in the trailing position (see illus-
tration "Sawing guidelines”). Depending on the base
material (hard, soft or masonry), the guide cut may be
made to a depth of between 4 and 5 cm. For the guide
cut, use a pressure of only up to 110 bar. This will pre-
vent the blade from wandering and ensure a straight cut.
Subsequent cuts
On completion of the guide cut, subsequent cuts can be
made with the saw arm in the trailing or leading posi-
tion. The depth of cut, on the other hand, depends great-
ly on the material and can be between 10 and 15 cm (see
illustration "Sawing guidelines", steps
II.
,
III.
and sub-
sequent steps). These cuts should be made at full pow-
er: 110–190 bar.
Ending the sawing procedure
■
When the concrete has been cut through, the blade
should be lifted out of the cut while still rotating. Switch
off the drive and water supply and move the saw head
to a suitable position on the rail.
■
All knobs on the remote control unit should be returned
to the neutral position and the hydraulic unit switched
off by turning the starting switch to OFF (position
I
).
■
Set the control switch on the hydraulic unit to the OFF
position (
0
).
■
If the hydraulic unit was switched off by way of the emer-
gency OFF button, the control switch on the hydraulic
unit must then also be returned to the
OFF
(
0
) position.
Printed: 08.07.2013 | Doc-Nr: PUB / 5069667 / 000 / 01
Содержание D-LP 32
