15
7EN125103 Rev. 13 • 2020
www.hillrom.com
Change of lifting accessories
Multirall™ 200 overhead lift is adapted to Liko
TM
Quick Release
System for safe and easy changing of lifting accessories.
L
ifting accessories that are not equipped with a Quick Release Hook
can easily be updated with a Quick Release Hook so that they can be
used with Multirall. See “Quick Release Hook”, page. 21.
Before lifting check that the Quick-release
Hook is correctly attached to the Q-Link or
Q-Link II, see illustration above.
Quick
Release Hook
Q-Link or
Q-Link II
Lift correctly!
Before each lift, make sure that:
– the Sling loops at opposite sides of the Sling are at the same height
– all the Sling loops are fastened securely in to the Slingbar hooks
– the Slingbar is level during the lift, see Figure 1.
If Slingbar is not level (see Figure 2) or if the sling loops is wrongly
attached to the slingbar (see Figure 3) lower the user to a firm surface
and adjust according to the Instruction for use of Sling in use.
An improper lift can be uncomfortable for the user and cause dam-
age to the lift equipment! (see Figure 2 and figure 3).
Figure 1.
Figure 2.
Figure 3.
Operation
Operating
Multirall™ 200 overhead lift is operated by lightly pressing the buttons on the
hand control. The arrows indicate the direction of movement. The movement
stops when the buttons are released. Multirall™ 200 overhead lift can also be
operated with the corresponding buttons on the end cover of the lift unit.
The arrow corresponds to the direction of travel when the lift is mounted with
the lift strap above the lift unit.
Operate the lift only when tension is applied to the lift strap!
Operate the lift only when the lift is correctly mounted to the carriage hook.
Hang-up HandControl Hanger
When not in use, the hand control
can be hung on the Hang-up
HandControl Hanger.
Installation of Latches
After installation, check that the latch
locks and moves freely in the sling bar
hook.
