11
7EN125103 Rev. 13 • 2020
www.hillrom.com
2. Insert the Adapter
MR/LR in to the
Q-Link or Q-Link II.
1. Feed out desired length of lift strap by applying tension
to the lift strap and simultaneously pressing the electrical
emergency lowering button.
Operate the lift only when tension is applied to the lift strap!
5. Connect the desired lifting accessory to the universal
connector at the lift unit, see chapter “Operation”.
Before the first use,
• Charge the lift’s battery for at least 8 hours, see chapter “Charging the Batteries”.
• Connect the Handcontrol MR-2 (Prod. No. 3136001) to the contact for handcontrol on the lift unit.
4. Raise the lift to an appropriate height.
NOTE!
Remove the Hang-Up HandControl Hanger when
the lift is installed with the lift strap above the lift unit.
Alt. A, with the lift strap above the lift unit
This alternative is recommended in cases where the lift is to be moved frequently between different rail systems, or when the
lift is to be used for room-to-room transfers.
A lift assembled with the lift strap above the lift unit must not be used in wet areas.
Multira
ll
Multira
ll
3. Connect the Adapter MR/
LR to the Carriage Hook for
MR/LR.
Recommended accessory for (
Alt. A, with the lift strap above the lift unit
).
Extension Arm Adapter MR Prod. No 3136040: Available as a service part only.
connect or disconnect the Adapter MR/LR to or from the Carriage Hook for MR/LR.
1. Insert the Adapter MR/LR in to
the Q-Link or Q-Link II.
3. Connect disconnect the Adapter MR
to/from the Carriage hook MR/LR
with the Extension Arm Adapter MR.
2. Place the Adapter MR/LR in
the Extension Arm Adapter MR, in its
intended holder.
Multirall™ 200 overhead lift can be mounted to the Carriage hook for MR/LR in two different ways. See alternatives below.
Assembly to Carriage Hook for MR/LR:
