5
Note
The grounding terminal is on the rear panel or side panel of the
device. The actual device prevails.
3.1.1
With Grounding Bar
If a grounding bar is available at the installation site, follow the
steps below.
Steps
1.
Connect one end of the grounding cable to the binding post on
the grounding bar.
2.
Connect the other end of the grounding cable to the grounding
terminal of the device and tighten the screw.
Grounding with Grounding Bar
3.1.2
Without Grounding Bar
If there is no grounding bar but the earth is nearby and the
grounding body is allowed to be buried, follow the steps below.
Steps
1.
Bury an angle steel or steel pipe (≥ 0.5 m) into the earth.
2.
Weld one end of the grounding cable to the angle steel or steel
pipe and embalm the welding point via electroplating or coating.
3.
Connect the other end of the grounding cable to the grounding
terminal.
Grounding with Angle Steel
3.2
Connect RJ45 Port
Use a network cable to connect the device to the RJ45 port of a
peer device such as network camera, NVR, switch, etc.
