HIKOKI GP18DA, Инструкция по эксплуатации, Страница: 34 / 56

English
34
e) When wheel is pinched, snagged or when interrupting a cut for any reason, switch
o ff the power tool and hold the power tool motionless until the wheel comes to a
complete stop. Never attempt to remove the cut-o ff wheel from the cut while the
wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the cause of wheel pinching or snagging.
f) Do not restart the cutting operation in the workpiece. Let the wheel reach full speed
and carefully re-enter the cut.
The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece.
g) Support panels or any oversized workpiece to minimize the risk of wheel pinching
and kickback.
Large workpieces tend to sag under their own weight. Supports must be placed under
the workpiece near the line of cut and near the edge of the workpiece on both sides of the
wheel.
h) Use extra caution when making a “pocket cut” into existing walls or other blind
areas.
The protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause
kickback.
GENERAL SAFETY INSTRUCTIONS FOR CORDLESS
DIE GRINDER
— Check that speed marked on the wheel is equal to or greater than the rated speed
of the grinder;
— Ensure that the wheel dimensions are compatible with the grinder;
— Abrasive wheels shall be stored and handled with care in accordance with
manufacturer’s instructions;
— Inspect the grinding wheel before use, do not use chipped, cracked or otherwise
defective products;
— Ensure that mounted wheels and points are fi tted in accordance with the
manufacturer’s instructions;
— Ensure that blotters are used when they are provided with the bonded abrasive
product and when they are required;
— Ensure that the abrasive product is correctly mounted and tightened before use
and run the tool at no-load for 30 seconds in a safe position, stop immediately if
there is considerable vibration or if other defects are detected. If this condition
occurs, check the machine to determine the cause;
— If a guard is equipped with the tool never use the tool without such a guard;
— Do not use separate reducing bushings or adapters to adapt large hole abrasive
wheels;
— For tools intended to be fi tted with threaded hole wheel, ensure that the thread in
the wheel is long enough to accept the spindle length;
— Check that the work piece is properly supported;
— Do not use cutting o ff wheel for side grinding;
000Book̲GP18DA̲ChS.indb 34 000Book̲GP18DA̲ChS.indb 34 2021/03/15 19:31:06 2021/03/15 19:31:06